|
|
P2K SD60
Below is installation guide for the the P2K harness. Steps are identical for all P2K locomotives.
1. Unplug DCC socket board and remove two screws securing light board. Remove light board from locomotive; it is not needed.
2. Turn DCC socket board over so that sockets face up. Use one of screws removed from the light board to secure DCC Socket to frame. See below.
*Important
Note*
Locomotive light bulbs must also be replaced. We recommend 14
volt bulbs because they do not get as hot as 12 volt bulbs.
3. Plug decoder into 9-pin plug. Next, plug the harness with the decoder into the 8-pin NMRA DCC socket.
Notice
how a screw is used to secure DCC socket board with sockets facing
up.
Installation of decoder and P2K harness is now complete!
|
|
Entire contents © Copyright Train Control Systems 2003-2007 • Last Modified:
October 31, 2004
|
