This photo shows complete installation. Notice the long metal bus bar that run across the top connecting the the trucks and the top of the motor has been removed. The MC2 decoder is glued to the loco frame underneath the left flywheel. It looks tight in this photo but there is actually plenty of room to spare. LED'S were used for the head lights instead of the supplied bulb. Notice the gray wire is soldered to the bottom side of the motor and the orange wire is soldered to the top side of the motor. Black wire is soldered to the bus bar at the front of the loco which is the left side track power pick up. The red wire is soldered to the right side track power pick up. The two right side track power pick ups are connected together with the red jumper wire.                             Red      Red wire jumper       Orange         Red wire jumper           Black

    Gray