|
|
TCS A4X -working front ,rear & ditch lights
fits as shown in the photo's
Remove the motor from the frame while it is out insulate with tape the bottom of
the frame. remove the contact strips on the motor very carefully so has not to
loose the brush springs. On each these strips solder wire just long enough to be
connected to the motor tags on the DCC chip. While the motor is out of the frame
remove the trucks and after removing the truck side frame ,remove the wheels and
gears. Next solder a wire to the metal sides of the truck in fact for one side
you could use the metal prong for the old pick up system. Assemble this all back
together wire to the A4X as per the instructions that come with the A4X.
For working lights I used 2mm tower LEDs you will need to cut the plastic at the
front a bit for clearance but once the body is back on it won't be noticeable.
The ditch lights are again 2mm LEDs and wired to the purple and green solder
pads on the A4X with the other wire from each LED solder to the BLUE (light)
wire tag.
|
|
Entire contents © Copyright Train Control Systems 2006 • Last Modified: Wednesday September 26, 2007 08:07 AM
