Decoder Information:   Scale Decoder Harness

Command Station Used with Decoder:   Maker Model

Did You Try a Factory Reset? I tried a factory reset but the problem still exists I did not try a factory reset Select...

New decoder is dead. It will not program on the programming track and does not respond to commands. New decoder works ok at the default address of 3 but will not accept programming changes on the programming track. Decoder programs ok on the main (ops mode) but not on the programming track. Decoder was installed and was running fine for months before it failed. Decoder was in service for awhile but occasionally it loses its address and must be reprogrammed on the programming track. Decoder runs ok for a short time but it stops responding to changes in throttle settings. It will resume normal operation again if the power is reset. Select...

Decoder failed the first time it was powered up, and I am fairly certain it was wired correctly. Decoder failed the first time it was powered up, but I may have wired incorrectly, or it may have shorted. Decoder failed the first time it was powered up, but I know that I wired it incorrectly. Decoder failed the first time it was powered up, and then I discovered the motor was not isolated from the chassis frame. Select...

Decoder runs fine but one or more of the light functions do not work.. The light functions work but the motor does not. There appears to be burn marks on the decoder. Smoke came out when the decoder failed. I did not notice any smoke or burning smell from the decoder. Select...