Walther 0-8-0
Z2P-VO decoder installation

Installation performed by N.L.G., A.G.

First remove the shell by squeezing it on either side of the tender and gently rocking it back and forth until it slips off the frame.

Now remove the shell from the tender and remove the plug (marked in red) by gently pulling it off.

Here is a picture of tender's board with removed plug.

Adjust the lenght of NMRA plug wires so that the decoder's board fits in the tender's cavity and also trim the NMRA pins to fit under the shell.Plug in our Z2P-VO decoder.

 

Unscrew the screw marked in red and remove the "front weight" also marked in red.

Here is how the installed decoder should look

Gently place tender's shell on its chassis