This installation is for N Scale LifeLike RS 2 uses TCS K2D4 Decoder and was performed by A.G.

The upper picture shows the LifeLike RS2 with its shell on.

 

This picture shows the locomotive's chassis with its shell taken off and the original lighting board. Be careful as you take off the shell because it is difficult to remove and can be broken easily.

 

Wrap kapton tape over the frame above the motor contacts as well as the protrusion of metal shown on the right in the image above. This is application of tape is crucial to ensure that the decoder and LED leads do not short against the frame.

 

This is a picture of the fully installed board. All in all it is not a very difficult installation. If you, for any reason, need to remove the K2D4, it will have a tendency to get hung up on the front LED, so you will have to lift this LED over the hump in the locomotive frame.

 

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017