This is installation of the 8 function TCS K0D8-A digital decoder for N Scale Kato P42 (all phases) performed by TCS

The TCS1/4" Kapton tape used in this installation is not supplied with the decoder and needs to be purchased separatly at your local TCS dealer or directly from us.

 

 

The three pictures above show the beautiful P42 Genesis Phase II engine prior to the K0D8-A decoder installation.

 

Gently, remove the shell from the chassis as shown above.

 

Here is a picture of the locomotive chassis after the shell removal where you can see the original light board.

 

The gray plastic clip (marked in red) holds the original light board and motor tabs in place.

 

Gently, remove the plastic gray clip by pulling it up.

 

Gently, spread two (marked in red) motor tabs. Be very careful not to break them!!!!

 

Remove the original light board.

 

Gently, remove the power pick-up copper rails as shown in the picture above. Be very careful not to bend these rails because they are very delicate and can easily break.

 

Here is a picture of TCS 1/4" Kapton tape that is used accross this installation. Kapton is not supplied with the decoder and needs to be purchased separatly at your local TCS dealer or directly from us.

Use a small piece of Kapton tape around the track power pick-up rail (marked in red) so that it is isolated from the motor tab. This is a very important step of the installation and ignoring it might damage the decoder!!!!!

 

The picture above shows properly done isolation of both motor tabs.

 

We suggest using small amount of solder to connect the motor tabs with the decoder (see picture above). Tint the copper pads with a little amount of solder and than solder motor tabs to the decoder.That will provide solid electrical contact.

Here is the picture of finished installation of TCS K0D8-A decoder. When run at speed step one you can see outstanding slow speed performance of this 8 function TCS decoder that is equipped with Back EMF.

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017