This installation is for N Scale Kato Glacier Express uses the TCS K7D4 Decoder and was performed by J.F.

First remove the shell by gently lifting it up and off.

Next, remove the original lighting board and take off the motor clips.


Attach the motor clips to the K7D4 decoder and insert it into the frame just like the original lighting board.

You will notice that both light tubes rest on top of the K7D4. Simply mark the light tubes in front of the LEDs and trim to length with a sharp knife.


Install the black plastic clip over the motor tabs and the installation is complete.

Finally place the shell back on and you are ready to run your locomotive.

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017