This installation is for the N Scale Atlas SD60-M and uses the TCS ALD4 Decoder - performed by TCS

First remove the shell by grasping it on either side (over the "Union" logo) and rock it back and forth until it slips off of the chassis.

Next remove the fuel tank.

Next loosen the screws highlighted above until you are able to spread the frame and lift out the lighting board. NOTE: you do not need to split the frame completely.

Insert the ALD4 into the frame, slip the motor tabs through the slots in the decoder and re-tighten the screws.

Once your locomotive looks like the image above you are ready to replace the shell and run your locomotive!

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017