This installation is for N Scale Atlas GP7 Ph.1 (2006 edition) and uses TCS ASD4 Decoder and was performed by A.G.

                 These three pictures above show detailed Atlas GP7 Ph.1 locomotive prior to the TCS ASD4 decoder installation.

 

Remove body shell and handrails by gently pulling up on the shell.  

 

Here is the picture of the Locomotive's chassis with its shell taken off and original light board installed.

 

Remove the fuel tank.

 

Loose the two Phillips screws that hold the two halves of the frame together and remove Locomotive's both trucks by gentle pull and twist to the side.

 

Make sure the motor tabs are not touching the frame- isolate them with kapton or electrical tape.

 

Add some solder to the power pick-up tabs so that the Decoder will have proper contact with the chassis.

 

Take both halves of the frame apart, remove original light board that the locomotive came with and insert the ASD4 decoder. and make sure they ARE touching their proper spots on the underside of the decoder. Put both sides of the frame together and make sure that all four contacts of the decoder are fitted into the chassis so that they create physical/electrical contact. Install both trucks, power pick-up rails , and tighten the two phillips screws on the chassis. Place the shell back and test your locomotive on the track.

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017