This installation of TCS LL8 Decoder is for HO Scale LifeLike Proto 2000 Heritage USRA 0-8-0 and was performed by A.G.

The locomotive is shown as a courtesy of Bob Jensen.


Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

http://www.techni-tool.com

The two upper pictures show the beautiful Lifelike Proto 2000 Heritage USRA 0-8-0 with its shell on prior to the LL8 installation.

 

Locomotive's tender close-up picture. The LL8 will be installed here.

 

Remove four phillips screws that holds tender's shell and its chassis together.

Here is the picture of the original light board after the shell removal where you can clearly see the 8-Pin NMRA socket.

 

Close-up of the 8Pin NMRA socket.

 

Gently remove the PC Board as shown in the picture above.

 

Remove two phillips screws that hold the original light board and chassis together.

 

Remove the original light board.

 

Install the TCS LL8 as shown above. Here is the picture of the TCS LL8 installed in the locomotive's tender. Make sure Pin #1 of the decoder is lined up with PIn #1 of the PC board. For more information see the manual that came with the decoder.


Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017