The MC2 decoder was installed in this loco because of its small size and the convenience of a harness. The top side of the board needs traces cut in two places. The bottom side of the board needs traces cut in four places. The wires are connected as follows: P1= orange, P4= black, P5= gray, P8= red. Connect blue to FL2 and RL2. Connect yellow to cathode side (banded side) of D1. Connect white wire to cathode side (banded side) of D2. Click on photos below for to enlarge them and read more information.
Click on photos below to enlarge and read more information.
Entire contents © Copyright Train Control Systems 2003-2007 • Last Modified: Friday August 29, 2008 08:15 AM