This installation of TCS T1 Decoder is for HO Scale LifeLike Proto1000 RDC and was performed by Robert E Petit,  Merrillville IN,  Duneland DCC


Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

http://www.techni-tool.com

 

Begin by removing the shell from the frame. Remove the couplers from both ends, and there are two screws at each end of the frame near the inboard side of the trucks. These are the only screws that need to be removed to separate the body from the frame

 

.

There are three places on the circuit board where there are traces that need to be cut. I usually make two cuts, one on each side of the “X”. I then remove the foil material to make sure that there is no path for current to “sneak” passed the cut.

 

I then mount the decoder using a small piece of double stick tape. This model was an RDC-3 with a Baggage/RPO end, and I made sure that the decoder was not visible through the windows. After the decoder is mounted, trim your wires to length. Leaving a little extra, just in case when you strip the wire it breaks off on you. Strip, tin and solder in place.  There is only one more thing to do to make your install complete. To make the lamps brighter I soldered a 330 ohm resistor across the resistor (in parallel) on the circuit board. Replace the body shell, and couplers, program your address and you’re all set to go!

 

 

 

 

 

 

P1 Orange
P2 Yellow
P4

Black

P5 Grey
P6 White
P7 Blue
P8 Red

Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017