This installation of TCS LL8 Decoder is for HO Scale LifeLike Proto 1000 F3A DCC Ready and was performed by A.G.

The locomotive is shown here as a courtesy of Larry Kolbe.


Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

http://www.techni-tool.com

The two upper pictures show the beautiful LifeLike Proto 1000 F3A DCC Ready with its shell on prior to TCS LL8 decoder installation..

 

Using phillips screw driver, remove the front coupler. Gently unsnap tabs from circles above fuel tank on both locomotive sides. Grasping the shell at the center top of both sides (being careful not to crush the grilles), lift the shell straight up and off of the chassis.

 

Picture of the locomotive with its shell taken off and original light board.

 

Remove the original light board by unscrewing two phillips screws.

 

Unplug the small PC board and remove the large light board as shown in the picture above..

 

Use a piece of double sided tape that will fix the decoder to the motor.

 

Place our LL8 decoder on the motor as shown in the picture above.

 

Plug the PC Board so that the Pin#1 of the decoder is lined up with Pin#1 of the PC board.

 

Here is a picture of completed TCS LL8 decoder installation.

 


Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017