This installation is for a HO-Scale Life Like Proto 2000 SD50
This was performed by our friends from DCC Xpress installations.
They offer high quality WOWSound installations for a flat rate complete with free return shipping!
You can find them at: www.dxinstalls.com
These items are available in the WDK-ATL-2 which was used for this installation.
With milling of the frame, they have been able to utilize a
AK-MB1 motherboard, WOW121 diesel decoder and UNIV-SH4C WOWSound kit.
Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157 http://www.techni-tool.com
HO Scale Life Like Proto 2000 SD50 shown prior to installation.
Shown with the shell off. To start, remove the two screws as highlighted above on either side of the existing lighting board. Remove the wire leads and remove the
board from the locomotive.
To allow a space for the motherboard and speaker, the frame must be milled as highlighted above to keep all the components below the original top of the frame.
With the lighting board removed, also remove the LED lighting saving these components for later reinstallation.
With the original lighting board removed and frame milled, trim, tin or lengthen the wires as necessary.
Using double sided foam tape, mount the AK-MB1 to the frame as shown and solder the motor and track pick up leads to it. Insulate these leads using small lengths of
TCS 3/32" and 3/64" shrink tubing if necessary.
Next, with the 25mm X 14mm WOWSound speaker inserted into the UNI-SH4-C enclosure, mount this assembly to the frame as shown and solder the wire leads
to the motherboard according to the included wiring diagram.
If your speaker enclosure installation covers the portholes on the enclosure, we recommend adding new port hole(s) similar to the original porting. Be sure that the new portholes are the same size and amount of the original and are vented freely into the locomotive We have found introducing a port of the correct size greatly increases the volume and sound quality of the installation. Too much or too little porting decreases the sound quality.
Place the original lighting back into their locations and solder the wire leads to the AK-MB1 according to the included wiring diagram.
TCS motherboards include on board current limit resistors for LED use. There is no need to apply external resistors for LED use.
You can now plug in your WOW121 decoder.
Lastly, in order to keep the wires neat and prevent possible shorts, lace the wires into a bundle using lacing cord, which is a wax impregnated string
used for wire bundling and making harnesses. There are many choices of lacing cord available from Digikey www.digikey.com.
We use part number 802534B BK032-ND
Now you can close up the locomotive and reinstall the coupler assemblies. Be sure to be mindful of wire routing and reassembly of the shell as to not damage
or foul the installation. Your Life Like Proto 2000 SD50 is now WOWSound equipped and ready to roll!
Other solder tips:
When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to. Click here for important information on properly Stripping and Tinning wire