This installation is for a HO Scale Proto 2000 GP38-2.
This was performed by our friends from DCC Xpress installations.
They offer high quality WOWSound installations for a flat rate complete with free return shipping!
You can find them at: www.dxinstalls.com
With milling of the frame, they have been able to utilize a
IB-MB1 motherboard, WOW121 diesel decoder and UNIV-SH4C WOWSound kit installation for the single front and rear bulb version.
These items are available in the WDK-LIF-3 which was used for this installation.
Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157 http://www.techni-tool.com
HO-Scale Life Like Proto 2000 GP38-2 shown prior to installation.
Shown with installation complete.
Other solder tips:
When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to. Click here for important information on properly Stripping and Tinning wire