The MC2 decoder was  wired into the circuit board supplied with the loco. The MC2 is a good choice for this installation because of its small size and convenient harness. Remove the shell by removing two screws located on the under side of the frame. The two yellow capacitors marked C1 and C2 must be removed. See photos below.

 Click on photos below to enlarge them and get more information. 

         

Click on photos below to enlarge and read more information.

 

       Before decoder installation. 

      

                             MC2 Decoder Installed      

 

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017