This installation is for a HO-Scale Bachmann EMD GP40 using a TCS WOW121 Diesel Decoder, AK-MB1 Motherboard with built in Keep Alive™ by TCS.

Kit Coming Soon! We are in the process of assembling all the items shown here into a new WOWKit.
Please check back here to see the new WOWKit when it arrives.


Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

http://www.techni-tool.com


HO-Scale train Bachmann EMD GP40 prior to installation.

 To start off this install, we must first remove the two screws highlighted above in red on the bottom of the fuel tank.


    Next, we must remove the two screws highlighted above in red found under the fuel tank on each side of the speaker.
With the screws all removed, lift the shell off of the frame. Take care with the handrails as you lift off the shell so they don't break.

The Bachmann EMD GP40 shown with the shell off.


Remove the two screws highlighted above in red, unplug and remove the wires from the original decoder board and remove it from the chassis.

Shown with the original decoder board removed. Trim and tin, or lengthen the wires as necessary.

Using clippers, remove the front LED from the original decoder board as shown above as highlighted in red.
Save this LED along with the original rear LED for reuse.

In the opening located on top of the frame, locate and remove the yellow cap highlighted above in red, clipping it from the motor.
This will not be needed.



Using double sided foam tape, attach the AK-MB1 motherboard to the frame and solder the motor and track pickup lead wires according
to your included wiring diagram.

Using a dab of hot melt glue, reistall the front LED base onto the frame in front of the AK-MB1 as shown above.



Mount the front LED to the base using hot melt glue. Insert the rear LED back into it's holder and then solder these leads to the AK-MB1
according to the included wiring diagram.

TCS motherboards include on board current limit resistors for LED use. There is no need to apply external resistors for LED use. 


Solder the existing speaker leads to the AK-MB1 and you can then plug in your WOW121 decoder.While making sure the speaker is secure in the frame, reattach the shell with the original screws into the frame. Replace the original fuel tank with the saved screws and your Bachmann EMD GP40
is now WOWSound equipped and ready to roll!



Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017