This installation is for a HO-Scale Atlas SD35 using a TCS WOW121-Diesel Decoder and AK-MB1. This install was performed by TCS.


Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

http://www.techni-tool.com
These items are available in the WDK-ATL-3 which was used for this installation.
AK-MB1 Motherboard with Keep Alive™ WOW121-Diesel Decoder UNIV-SH1-C Speaker Kit
Click here for more information on the WDK-ATL-3 and the rest of the WOWDiesel Kits line.

Please reference the installation of this WOWKit in a Atlas Master GP40.

Both models feature the same chassis and therefore the same installation procedure.

Atlas Master Line GP40 Installation

You have now installed a TCS WOW121-Diesel Decoder, AK-MB1, and UNIV-SH1-C into your HO-Scale Atlas SD35.


Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017