This installation of TCS A4X Decoder is for HO Scale Atlas RS3 and was performed by Les Cattin of Vintage Hobbies in Kokomo, Indiana


Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

http://www.techni-tool.com

I used an A4X for the installation.  The old Atlas setup had the single light bulb in the center of the board. 

Most people cut and polish the light tubes to the length that is needed, but what I did was use two small incandescent bulbs side by side in the same spot in the center of the board.

I  made a "T" out of electrical tape between the 2 bulbs which mostly isolated the light from the front bulb from brightly lighting the rear light pipe.

 I assembled the loco, and the light in the direction of travel, of course, is on.

  You can see it both front and rear but the opposite light tube isnít getting as much light so it is automatically dimmed. 

What you end up with is a very nice dim glow in the opposite light.  It works great. I am also going to dissemble the trucks and solder the pickup wires to the wipers. 

The original Atlas design used a push on cap to attach the wires. 


Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017