This installation of TCS DP2X-UK Decoder is for HO Scale Atlas Track Cleaning Car and was performed by A.G.


Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

http://www.techni-tool.com

The upper pictures show the beautiful Atlas Track Cleaning Car with its shell on prior to the TCS DP2X Decoder Installation.

 

Gently remove the wheel to access the philips screw (Marked in red).

 

Unscrew Phillips head screw and remove the truck assembly from the body.

 

Unscrew the two circled in red Phillips head screws to release top cover.

 

Remove the top cover.

 

Remove the marked in red 8-PIN DCC Jumper plug.

 

Install the TCS DP2X-UK Drop-In decoder so that the PIN #1 of the board match PIN#1 of the decoder. (See the decoder manual for more info).

Reverse above procedures to return Track Cleaner to operational use.

According to the Atlas manual that came with the unit, no more than 9V should be applied to the cleaner. If more than 9V. is applied, the solder that connects the pick-up spring to the trucks will melt, and the connection will be broken, avoiding damage to the motor. Please, remember that the Track cleaning car MUST be given a different address from the locomotive that is pulling it. If you fail to do this than you may inadvertently apply more than 9V to the motor.

TCS recommend to set the Vhigh (CV5) to the value of somewhere between 180-200 and do not exceed speed step 100 during the operation.


Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017