This installation of TCS T1 Digital Decoder is for HO Scale Athearn GP60 and was performed by Jean Lacroix, Canada.


Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

http://www.techni-tool.com

The upper picture shows the beautiful Athearn GP60 with its shell on prior to the TCS T1 Decoder Installation.

 

This locomotive comes stock with 1.5volts lamps and with a DCC plug that is very easy to turn to DCC. First, gently place your locomotive upside down on a piece of foam or a towel so you do not damage the paint or small details located on top. Remove the two screws that hold the coupler boxes. Hold the body where it is more solid in one hand and the fuel tank in your other hand and pull gently, the body should come off. Inside you will see the motor and an electronic circuit board that sit on top of it.

 

At the front end, there is a DCC “dummy” plug at the end of a harness that you will remove.

 

Remove the "Dummy" plug.

 

You will then put in its place the TCS T1 decoder in place of the “dummy”.

 

You are almost done! Just put back the body, the coupler boxes and the screws. The locomotive is now ready to go on the track.

 


Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Home
Entire contents © Copyright Train Control Systems 2004-2017